What is the compact manual shield box, and where does a hinged lid fit?
It is a compact benchtop metal RF test enclosure with a lift-up lid that hinges at the rear. A lever handle on the lid compresses the seal in one motion, and gas struts on both sides hold the lid open. The interior connector panel sits at the rear of the cavity, so with the lid open you face the connections directly. It needs no compressed air, which means it can sit on any bench, and it suits small modules, boards, and components for RF testing, design debug, incoming inspection, and repair re-test.
Key points
- Rear-hinged lift-up lid with a lever handle for one-hand closing
- Gas struts keep the lid open, leaving both hands free
- Rear connector panel is directly accessible when open
- No air supply required, so it works on any bench
- Sized for small modules, boards, and components rather than complete units
Products this applies to
Discuss this configuration
Send the device details and the measurement you need to make. We will confirm which specifications are fixed and which need verification on your sample.
Contact engineering